top of page
WhatsApp Image 2026-02-13 at 13.16_edited.png
Untitled design.png

Cricket Bowling Line and Length: A Simple Target-Practice Guide

Writer: adarshking12364
adarshking12364
Oct 20
5 min read

To practise cricket bowling line and length, choose one clearly marked landing area, bowl at a controlled effort and record where each first bounce lands. Keep line and length separate in your notes: a ball can be straight but too short, or the right length but too wide. Improve that repeatability before adding pace, variations or a batter.


Cricket bowling line and length: a clear landing target in a practice lane

AI-created editorial illustration of a target-bowling setup.


At a glance


  • Pick one intended delivery and a generous flat target.

  • Use the first bounce to judge the landing point, not where the ball finishes rolling.

  • Keep the ball model, starting mark and surface unchanged for a comparison block.

  • Record misses by direction; a single total score hides useful information.


What is the difference between line and length?


Line is the delivery’s lateral direction relative to the batter and stumps. Length describes how far down the pitch the ball lands. In a target drill, mark both: the target’s width represents a line corridor, while its depth represents a length zone. That makes “I missed” into something a player can actually work on.


There is no one good-length spot for every bowler, batter and pitch. A coach should choose a landing area for the intended ball and the player’s stage. Do not copy an adult full-pitch target into a junior session without adapting the pitch and task.


ECB’s Chris Jordan target-drill article shows how specific targets can represent different deliveries. The simplified exercise below uses that clear-target principle, not his elite workload or late target changes. Its example scoring is an editorial practice method, not an official assessment.


How do you set up a useful target lane?


Choose an authorised practice area with a clear run-up, safe follow-through and contained ball path. Nobody should stand on the target or retrieve balls while bowling continues. Use flat markers or permitted chalk, not a hard object that could redirect the ball. Check with the venue before marking its surface.


For an introductory setup, a coach might start with a rectangle roughly one metre wide and two metres deep, located for the chosen delivery on an age-appropriate pitch. These are adjustable teaching dimensions. Widen the area if the player is chasing a tiny spot instead of maintaining balance and rhythm.


Use one comfortable starting mark and one ball type. A batter is unnecessary for the first block. Agree how the observer will identify the first bounce from a safe position outside the ball path. If the view is unclear, record “unseen” rather than guessing a hit.


A five-step line-and-length practice method


  1. Warm up appropriately, inspect the lane and agree the intended delivery with the coach.

  2. Bowl a small controlled block, such as six deliveries, within the player’s existing workload plan.

  3. For each ball, mark target hit, short, full, left or right. A miss can have both a line and length label.

  4. Pause to identify the most common miss, then choose one coaching adjustment.

  5. Repeat a comparable block only when appropriate; compare the pattern before changing the challenge.


The six-ball example is a convenient recording unit, not a recommended daily workload. Include bowling done elsewhere, allow recovery and follow the relevant age-group and local fast-bowling requirements. Stop for pain or a deteriorating action and seek qualified coaching or medical help as appropriate.


ECB’s recreational regulations page links its fast-bowling and safety guidance. Use the rules applicable to your own programme; an accuracy game does not cancel workload or protection requirements.


What does the miss pattern tell you?


Observed pattern

What to check first

Useful next decision

Mostly short

Target placement, effort and rhythm

Keep line target; review length with coach

Mostly full

Same starting mark and delivery intent

Review one adjustment; avoid extra pace

Mostly left or right

Alignment and repeatable approach

Keep length zone; focus on line

Scattered everywhere

Task difficulty or changing setup

Simplify target and effort before scoring


These are prompts for observation, not a remote diagnosis of a bowling action. A coach may see a technical cause that a scorecard cannot. Avoid telling every player to force the same arm position merely because the misses have the same label.


ADRIN Cricket Wind Ball 90g product image

ADRIN Wind Ball 90g is listed for cricket practice, including bowling practice. A lighter training model does not reproduce every match-ball response.


Two examples: turn the score into a decision


Scenario 1: a beginner lands four balls straight but short


In a six-ball example, four first bounces land inside the line corridor but before the length zone. The player has not failed at everything: line is already the more repeatable component. The coach keeps the corridor unchanged and works on the chosen length at a manageable effort. Shrinking the width or adding a batter would introduce a different task.


Scenario 2: a club bowler loses control when speeding up


A bowler hits the target more often during a controlled block, then scatters deliveries after increasing effort. The coach returns to the previous rhythm and checks whether control returns. Only then is a modest progression considered. The aim is a repeatable intended delivery, not a fast-looking action with no reliable landing point.


Which practice ball should you use?


Choose the model for the players, surface, venue and coaching objective. Keep it consistent while comparing blocks. Changing weight, firmness and surface together makes it difficult to know whether the apparent improvement came from technique or equipment.


ADRIN Sports, led by CEO and CMO Adarsh, offers different practice-ball options for these session decisions.


The Wind Ball 90g listing describes a high-bounce practice ball with a raised seam and bright colour choices. Confirm suitability with the coach rather than assuming lighter means appropriate for every setting.


Polysoft 120g is listed as a soft practice ball with a raised seam. Its role and stated weight differ from the Wind model; compare for the drill rather than treating the two as interchangeable.


ADRIN Polysoft Cricket Ball 120g product image

Official ADRIN Polysoft 120g photograph. Keep a single chosen model through each accuracy comparison.


If the session is intended to prepare for a specific fixture, read the practice-ball versus match-ball guide before choosing the equipment. Match eligibility is a separate question from usefulness in an introductory target drill.


Common mistakes that spoil an accuracy session


Scoring where the ball stops confuses bounce and roll with landing accuracy. Moving the target between deliveries makes the score incomparable. Chasing a tiny target too early can turn an otherwise relaxed exercise into a tense effort to steer the ball. Keep the task simple enough for the player to understand the feedback.


Also inspect the ball before starting: a damaged or badly altered ball adds another variable. The replacement-ball checklist helps separate equipment condition from the practice goal.


Quick questions about target bowling


Should I bowl faster to reach the target?


Do not use pace as the automatic fix. Ask the coach to check the target location, pitch length and action first. A target that is unsuitable for the player should be moved, not reached by straining.


Is hitting three out of six good?


It is a baseline only when the conditions are recorded. Target size, distance, ball and intended delivery all affect the score. Compare a player’s like-for-like blocks; do not present an arbitrary percentage as a universal standard.


When do I add a batter or a second target?


After the basic task is repeatable enough for that progression to have a purpose. Add one challenge at a time, under the appropriate supervision and protective setup.


Leave with one clear improvement


Record the setup, the first-bounce pattern and the next coaching decision. A short, well-observed block gives more usable feedback than a long session where every ball, target and effort level changes.


Editorial note: this topic was selected for practical training usefulness; keyword-volume and search-growth metrics were not available.


Explore the equipment discussed


Official product photographs and individual specifications; choose for your session rather than appearance alone.




  • ADRIN Cricket Wind Ball 90g official product photograph
    ADRIN Cricket Wind Ball 90g
  • ADRIN Polysoft Cricket Ball 120g official product photograph
    ADRIN Polysoft Cricket Ball 120g
 
 
 

Comments


Image by Gradient Wallpapers
7DCEE877-12F2-4122-B69C-BFD200744B10.png

CUSTOMER CARE

TRACK YOUR ORDER

CONTACT US 

ENQUIRY 

CONTACT INFORMATION

📞  CONTACT: 

+91 7009956467, +91 9855837914

📧 MAIL :

sportsadrin@gmail.com

Choose your ADRIN emails

bottom of page