Wet Cricket Practice Ball? How to Dry, Check and Store It
Updated: Oct 14
If a cricket practice ball gets damp, pause the drill, wipe off visible moisture with a clean cloth and let the ball and kit dry separately before storage. Check the ball’s surface, shape and grip before it goes back into play. The right response depends on the ball’s construction and the maker’s care instructions.

At a glance
Wipe first; air-dry before packing; inspect before reuse. If the playing surface or visibility is unsafe, stop the session. A damp ball is also a prompt to check the bag, not just the ball.
What should you do as soon as a practice ball gets wet?
Move the ball out of the wet area. Use a clean, absorbent cloth to remove surface water; do not scrub hard at a seam or coating. Set it in a ventilated, shaded place instead of sealing it in a bag while damp. Keep the ball away from direct heat unless its maker specifically permits it.
For example, after a brief shower at a school net, the coach can put used balls on a clean towel while players reset the drill. Separate the visibly wet ones so nobody assumes the whole bucket is ready for the next group.

How do you know whether the ball is ready to use again?
Check four things by hand and eye: Is the surface dry? Is the ball still round? Are its seams or joins intact? Can the player grip it normally? Remove a ball from the drill if it is damaged or behaves unexpectedly. This is a practical inspection, not a laboratory test.
Check | What to look for | Next step |
Surface | Visible moisture or dirt | Wipe and let dry |
Shape | Flattening or swelling | Set aside for assessment |
Seam or join | Loose or damaged edge | Do not use in fast feeds |
Grip | Slipping in the intended drill | Pause and reassess conditions |
Should you keep training on a wet pitch or grass?
Decide on the whole playing area, not the ball alone. Slippery footing, poor visibility and unpredictable bounce can make a drill unsafe even if a ball feels dry. Change to a controlled indoor skill task or wait until conditions improve. Match playing conditions have formal umpire decisions; a coach’s training decision should be conservative.
The ICC playing conditions address wet balls and conditions in match play. Those rules do not replace local coaching judgement for a school or club session.
How should you store practice balls after the session?
Empty the ball pocket, remove damp towels and leave the bag open to dry. Store balls only when both the ball and storage space are dry. Keep different models apart so the next coach does not mistake a soft beginner ball for a firmer training ball.

A simple five-minute handover checklist
1. Collect and count the balls. 2. Wipe off surface moisture. 3. Separate damaged or doubtful balls. 4. Dry the bag and towels. 5. Label or sort models before storage. The exact drying time depends on the product and conditions; do not invent a fixed number.
Which ADRIN balls might belong in this kit?
The 90g Cricket Wind Ball and I-10 110g Soft High Bounce Ball are separately listed ADRIN practice options. The Polysoft 120g is another model. Choose by player, bat, surface and drill; use each listing’s details and care guidance rather than assuming all practice balls respond to water the same way.
The useful habit
Dry, inspect and sort before the next session. A few minutes of care makes the next drill easier to organise and helps the coach spot a ball that should leave the kit.
ADRIN practice balls to compare
These catalogue cards link to the exact models mentioned above. Check the listing and match each ball to the drill.
ADRIN Sports, led by CEO and CMO Adarsh, includes cricket practice balls in its range.










Comments